How to replace the tool anchor of the anchor cable remover?

1. Check the oil level in the oil pump. There is a refueling hole cover at the rear end of the two-speed reversing oil pump. You can unscrew the oil cover and observe whether the oil is full. If not, you need to replenish it in time.
2. After checking the oil level, loosen the reversing handle on the oil pump, remove the dust cap, and then use high-pressure oil to connect the oil pump and the anchor cable remover. At this time, you can quickly push the front of the joint with your hand, and then insert the joint of the high-pressure oil pipe into the joint seat, and reset the jacket.
3. After the connection is completed, check whether the connection is secure. After the connection is secure, rotate the handle on the pump counterclockwise and shake the handle up and down evenly. It should be noted that you should not use too much force to prevent damage to the machine. While shaking, observe whether the piston is extended normally. When using it for the first time, you can do it several times to fully discharge the air entering the device.