Blog

2026-8-10

How to quickly diagnose Pneumatic Rib Drill faults
I. First Step: Initial External Inspection 1. Air Source Status Check: Confirm that the compressed air system pressure is within the rated range of 0.4-0.6MPa. Check for bends, leaks, or blockages in
2026-8-07

Common Pneumatic Rib Drill Faults
I. Gas System Faults Difficulty starting the drill; low speed under no-load, failing to reach rated power. Sudden shutdown during operation; unable to function normally after restarting. Black smoke e
2026-8-05

Repair methods for common Pneumatic Rib Drill malfunctions
I. Insufficient Power, Reduced Speed/Torque 1. Clean the intake pipe and intake filter screen, and unclog any blocked exhaust holes to ensure smooth airflow. 2. Replace damaged air supply hoses, and r
2026-8-03

What are the common malfunctions of the Pneumatic Rib Drill?
1. Pneumatic System Failures: These include difficulty starting, low no-load speed, sudden shutdown during operation, and black smoke or unusual odor from the exhaust port. These are often caused by i
2026-7-31

How to quickly troubleshoot Pneumatic Rib Drill
I. Initial Inspection of External Air Supply Line 1. Check if the air supply valve is fully open and confirm that the air source pressure is within the standard range of 0.4-0.6 MPa. 2. Check the air
2026-7-29

Common problems with Pneumatic Rib Drills
1. Insufficient power and slow drilling speed: Often caused by an incompletely open air supply valve, blocked/leaky air pipes, worn drill bits, incorrect drill specifications, or excessively hard rock
2026-7-27

What is the typical maintenance cycle for Pneumatic Anchor Cable Tensioning?
1. Daily Maintenance (per shift/day): Clean equipment of coal dust and oil stains, check for leaks in oil pipes and joints, and complete basic inspection and maintenance. 2. Weekly Maintenance (7 days
2026-7-24

How to determine if a Pneumatic Anchor Cable Tensioning needs repair?
I. Obvious Faults Requiring Immediate Repair 1. Hydraulic System Abnormalities: Oil seepage, dripping, or spraying occurs at the jack, oil pump, oil pipe joints, and valve blocks; pressure drops rapid
2026-7-22

How to safely operate Pneumatic Anchor Cable Tensioning
I. Pre-operation Safety Requirements 1. Personnel Qualifications: Operators must undergo specialized safety training and pass the assessment, be familiar with the equipment structure, operating proced
2026-7-20

What are the precautions for operating Pneumatic Anchor Cable Tensioning?
I. Pre-operation Preparations 1. Environmental Safety Confirmation: The gas concentration in the underground working area should be ≤1% (≤0.8% in high-gas mines), with good ventilation and no ri
2026-7-17

How exactly does Pneumatic Anchor Cable Tensioning work and function?
I. Pre-operation Preparation 1. Environmental Safety Confirmation: Check that the roof of the working roadway is stable, with no risk of loose rock or rockfall, and that the underground gas concentrat
2026-7-15

How to determine if the motor of a Pneumatic Roofbolters is damaged?
I. First, rule out external non-motor faults: 1. Air source verification: Use a pressure gauge to check the air inlet pressure, confirming that the air pressure is stable between 0.4-0.63MPa, ruling o

First 12 3 4 5 6 7 Last 1/11