Reasons For The Air Leg Of A Pneumatic Anchor Drill To Be Weak

The reasons for the air leg of a pneumatic anchor drill to be weak may include abnormal air compressor, blocked air circuit, insufficient oil or poor lubrication, and insufficient air pressure. When the air compressor is abnormal, it should be checked and repaired or replaced. If the air circuit is blocked, it needs to be checked and cleaned. Ensure that the sliding parts are adequately lubricated, add lubricating oil in time, check whether the oil is sufficient, and avoid insufficient oil or thickening of the lubricating oil. Adjust the air pressure to ensure that the air leg works normally.